Steel Products

Crittall™ Window Homelight™ Window Range

Homelight 'L'™ Range Reversible casements

Manufacturer and reference: Crittall Windows Limited, Homelight ‘L’™ Reversible supplied (and installed) by Anglia Fixing limited.

Generally manufactured in accordance with BS 6510, exclusively designed sections for double glazed versions, otherwise F section.

Weathertightness: To BS 6375: Part 1.
Exposure category (design wind pressure): 2400 (Pa).

For air permeability, water-tightness and wind resistance data see Table AA.

Operation and strength characteristics: To BS 6375: Part 2.

Construction: All frames have welded corners and are flat and square within normal manufacturing dimensional tolerances of ± 1.5mm.

Galvanising: All components including steel attachments, coupling members and ancillaries: Hot-dipped after manufacture to BS EN ISO 1461:1999.

Glazing details: Will accept double glazing up to 24mm in thickness.
Glazing beads present no horizontal ledges on which dust and dirt can gather.

Weather-stripping: Gaskets complying with BS 4255: Part 1 manufactured from neoprene.

Ironmongery/accessories: Safety catch, storm catch, handle and face applied friction pivots.

Finish as delivered: Galvanised or Duralife™ (see clause 331) in a range of colours.

Dimensions & Reference Numbers:
HEIGHT LENGTH
PREFIX 'N' = 997mm
PREFIX 'ZN' = 1237mm
1486mm
923mm NC13R
NC13R
ZNC13R
NC14R
NC14R
1067mm   NCO13R
ZNCO13R
NCO14R
1218mm ND13R
ND13R
ZND13R
ND14RS
ND14RS
1513mm NDV13RS
NDV13RS
ZND13RS
 

* Not available in Homelight™ double glaze construction.

Notes:

These are outside elevations. Where windows can be handed, left hand elevations are shown.

Except where marked by asterisk above, all window are available in Homelight™ double glaze construction. Use the suffix 'DG' after the type reference (e.g. ZNC2DG).

Some of the illustrations are drawn in 'N' range proportions; some are drawn in 'Z' range proportions. The type reference printed immediately under the illustrations indicates which is shown. In most cases both 'N' and 'Z' sizes are available.

Where the letter A appears within an illustration, it is recommended that an adjustable Trickle ventilator should be specified to provide secure, weather-tight trickle-ventilation at the head of the pane. Trickle ventilators can be fitted in any pane in a ‘N’ or 'Z' window 508mm or more in length.

Note that safety glass may be required in certain panes depending on sill height (see BS6262) so 'FSB' (full sublight bar) windows could be more economical to install.

Top hung fanlights in windows suffixed 'F' and 'V' are 306mm and 250mm high respectively. The minimum size of inner or outer frame for special manufacture of single glazed windows is 242mm.

In the case of DG construction, minimum frame sized vary according to frame proportion. 285mm x 480mm and 400mx400mm are typical. Consult us for advice.

It is recommended that a template is produced for curved and radius windows (for refurbishment).

A range of brochure and specification sheets relating to the Homelight range may be downloaded from our Brochures page.

Back to Top